Previous Topic

Next Topic

Book Contents

Book Index

Reference Measurement view

The Data Collector Reference Measurement and the Data Receiver Reference Measurement views give overviews of all fully surveyed points that have been surveyed in a site setup round. For a detailed description of the columns in the table see the section below.

Note - For a point to appear in the list, it must have been measured in both faces, forward and backward, during the site setup. If only one face is available, the point is discarded. The entries for disabled points are grayed out.

These measurements serve as reference for which the depending Integrity Monitor module can compute and visualize the current displacements. From these measurements the coordinates for the reference points have been calculated.

The table: All available columns

Column

Description

Status icon

Backsight points display a status icon.

control point icon

 

Point Name

Target point name. Must be the same in the global point list. Each point must be measured in two faces to appear in the point list.

Hz Circle Reading

The horizontal angle between reference circle 0 and pointing direction.

V Angle

The vertical angle between total station and target. In degrees.

EDM Distance

Distance of the prism from the Electronic Distance Measurement device.

Face

One of either 1 or 2.

Measurement Time

Time of the measurement.

See Also

Site Setup dialog

Data Receiver - Site Setup dialog

Data Collector Round Measurements view

Data Collector Round History view

Data Collector Total Station Info view

Data Collector Properties - GKA Output

Data Receiver Round Measurements view

Data Receiver Round History view

Data Receiver Total Station Info view

Data Receiver GKA Raw Message view