Inserting modules

To insert a module, do the following:

• At the Tree view, select the parent module(s) and do one of the following:
  • From its shortcut menu, select Insert Module.
  • Use the INS key on your keyboard.

  The Insert Module dialog appears. It offers all available and connectable modules to be loaded at their point. With multiple selected parent modules, the Insert Module dialog displays only those modules connectable to all selected modules. Use the Insert Module dialog to select a module type, select a Controller and / or Container, if applicable and click OK. The module's Properties dialog appears, which lets you add or select one or several module configuration(s) specifying the properties of the new module(s). After you have accepted the selection with Finish, the new module is added to the tree.

  The module(s) selected in the Tree view will act as parent(s) for the modules selected in the Insert Module dialog.

Tip - You may insert multiple modules of a type at a time, if you have already set up a configuration specifying the module properties for each of the modules. In this case, use any of the options listed above to go to the Configuration tab of the module's Properties dialog, select the configurations and click Finish. All module will be created in the specified Controller and Container under the same parent (either the root or a parent module).

Canceling the insertion of modules

What to do, if you have selected to insert multiple modules for insertion, but want to cancel the insertion? Depending on the module type selected for insertion, one of the following methods is available for canceling the insertion.

• During specification of the properties of the module, click the Properties dialog's Cancel button to stop the creation of new modules.
• If a process dialog appears, it displays a Cancel button that stops the creation of new modules.

Note - Modules already added to the tree before you clicked Cancel will persist. Consider removing these modules using their Remove Module shortcut menu command.