|
|
|
|
|
The table of the Terrestrial Engine PP Status view gives an overview of the latest results of all points the module has found in the last JobXML file. All times shown here are in the time system you have selected for the Trimble 4D Control Server system.
During processing, the overview of the last round measurement displays above the table the current measurement round that is being processed and the total number of rounds in the file (for example: Processing round number 8 of 20 rounds). The data displayed in the table is the data as measured in the latest available round. Points for which no current measurements have been found, do not appear in the table.
Column |
Description |
||
|---|---|---|---|
Status icon |
Control points display a status icon. |
|
|
Point Name / Target |
Must be the same in the global point list. Each point must be measured in two faces to appear in the point list. |
||
Point Name / Total Station |
The name of the point the total station instrument was located on. |
||
Hz Circle Reading |
The horizontal angle between reference circle 0 and pointing direction. In degrees. |
||
V Angle |
The vertical angle between total station and prism. In degrees. |
||
EDM Distance |
Distance of the prism from the Electronic Distance Measurement device. In the selected length unit. |
||
s Hz Circle Reading |
Known standard deviation of the horizontal angle to North as entered by the observer. In degrees. |
||
s V Angle |
Known standard deviation of the vertical angle as entered by the observer. In degrees. |
||
s EDM Distance |
Known standard deviation of the EDM distance as entered by the observer. In meters. |
||
Face |
One of either 1 or 2. |
||
Measurement Time |
Time of the measurement. |
||
The results displayed here are the last available measurements. To get displacements to the reference measurements and errors, make sure a Integrity Monitor module is added to the Terrestrial Engine PP. There, go to the Current Displacements module-view. The Displacement Chart module-view displays a history of measurements.
Tip - The default period to be displayed in the Integrity Monitor Displacement Chart view is 30 minutes. For many monitoring applications, it may be a good idea to increase the display period considerably, for example to weeks, months, or even years.
