Select GNSS Receivers dialog

The Select GNSS Receivers dialog appears, if you do the following:

1. Add one of the following modules to the system or change its properties:
   • Ephemeris Manager
   • Ionospheric Activity
   • RTO Multistation
   • RTO Net module, with the RTCM3Net output type selected
   • Synchronizer
2. Set the focus onto the x GNSS Receivers selected value field and click the browse button.

Use the dialog to select GNSS Receiver modules from the list of connected modules.

Sorting modules according to a characteristic

By default, the modules are alphabetically sorted according to their configuration names. By clicking the column headers of the list one may sort the list items according to any of the displayed properties, which include:

• Select, i.e. the selection status
• Receiver Name, the configuration name of the receiver module
• Longitude (geographical coordinate)
• Latitude (geographical coordinate)
• Device Manager Configuration Name, the configuration name of the parent Device Manager module.

Selecting modules

To select a module, make sure the respective check box is selected. There is no limitation to the number of selected instruments. The All button enables all connected modules for the current configuration, the None button disables all. At least one module has to be selected. By default, no module is selected.

Modules not in use

The list item will display "Not in use" for the geographical coordinates and the Device Manager configuration name, if the following happens:

• A receiver module has been selected for contributing to a Synchronizer module, and the selection was accepted.
• Thereafter, the receiver module has been removed from the Device Manager or is disconnected from it. The latter case may happen, for example, if in a distributed system the connection between two Controllers fails and the Device Manager is located on a different computer than the receiver module.

Thus, the selection of the disconnected receiver module is kept by default until the physical connection is up again.

If one removes the selection from the "Not in Use" receiver module, this entry will disappear from the list of modules after acceptance of the dialog as long as the module is not reconnected to the system.

Receiver modules added later

If receiver modules are added to the system after the setup of a Synchronizer module (or if a physical connection is up again), they will automatically be available for selection, when you re-open this dialog.