Current Displacement Values dialog

This dialog appears if you do the following:

1. Do one of the following:
   • In the Tree view, go to the Integrity Monitor item.
   • Go to the Integrity Monitor Current Displacements module view and set the focus anywhere.
2. Open the shortcut menu and select Apply Displacements.

Use the Current Displacement Values dialog to view the current displacement values and to select ...

• for terrestrial applications: the points ...
• for GNSS applications: the stations ...

for which you want to apply the current displacements.

List of points / stations and their current displacement values

For all points or stations that are not held fixed the list displays the current status from the Integrity Monitor module and the Northing, Easting and height displacements (delta difference values, D) from the known positions of each point. Fixed points and stations do not appear in the list, since their displacement values are always zero. If for a point/station no displacement offset could be estimated (for example, because it was not part of the set of rounds or a receiver was disconnected), no position update is offered.

The displacements shown here always refer to the default coordinate system, even if the point's or station's individual coordinate system has been rotated.

Check boxes let you select the points/stations. By default, no point/station is selected.

Tip - You should not apply displacements for stations, whose three-dimensional 3-s value is higher than the disarm threshold specified in the Integrity Monitor properties (status is gray). The estimated position differences of these stations are assumed to be not reliable.

Note – The displacements displayed in the Current Displacement Values dialog are calculated at the time when you select the Apply coordinate displacements command. Even if the delta differences change in the Current Displacements view, the Current Displacement Values dialog continues to display the displacement for the time when the dialog was first created.

Select All / Select None buttons

The Select All button selects all points/stations for position update, the Select None button disables all.

Apply button

Click the Apply button to add the current displacement values to the known positions of all selected points/stations.

Note - Modules processing GNSS data and using the station positions for calculations will reset the calculation of the baselines to which new coordinates are applied. The RTK Engine will reset baseline estimation for all baselines connecting the respective station to any other station.