Previous Topic

Next Topic

Book Contents

Book Index

Select Network Interface dialog

This dialog appears if you do the following:

  1. Add or select a module that requires a connection to incoming or outgoing data and select the TCP/IP server connection type.
  2. Go to the Connection Settings category referring to the TCP/IP server connection type.
  3. Set the focus onto one of the Network interface setting and click the browse button.

Use the Select Network Interface dialog to specify the network interface and, optionally, an IP address on it.

Select a network interface

The selection field displays the Any Interface selection and all network interfaces installed at the computer of the parent Controller.

Select an IP address

The selection field is only available if Any Interface is not selected and if your computer is configured to not automatically obtain IP addresses using the DHCP protocol. Use it to select an IP address from all currently configured IP addresses for the selected network interface.

See Also

TCP/IP Server connection settings