|
|
|
|
|
When you add the RTX Engine module, the RTX Engine Properties dialog appears with this tab.
If you select the module in the Tree view after you have added the module, the categories and settings of this tab appear in the Properties view.
Use the General Settings tab to view and edit the RTX Engine properties, such as the satellite system parameters and logging settings.
Satellite Systems: The RTX Engine can make use of several satellite systems: GPS, GLONASS, and QZSS. By default, the RTX Engine module uses both, the GLONASS and GPS satellites (GPS and GLONASS option is selected). Other options are GPS only (GPS), GPS and QZSS, and GPS, QZSS and GLONASS.
Use logging filter: If set to No, the processing results are written into the database with the highest available data rate. If set to Yes, the additional Logging data rate property will be available, which lets you specify a data rate at which the processing results are stored in the database.
Logging data rate: Only available, if the Use logging filter property is set to Yes. Lets you select a rate at which the processing results are written into the database. If the input data is coming at a higher rate, the written values will be mean values. If it is coming in at a lower rate, the logging data rate is reduced to the incoming data rate. Available data rates are between 20 Hz and 10 minutes (Default: 15 seconds).
Rover position results: If set to Yes (default selection), the RTX Engine module stores its processing results into the database. If set to No, the module's Chart view is not available anymore, since no results are available for display.
Rover integrity support: If set to Yes, the RTX Engine module stores the processing results into the Trimble 4D Control Server RoverIntegrity database. The Rover Integrity module will be able to read the data and to use it for analysis. By default, set to No (no storage). If your system does not support rover integrity, the setting is not available for editing and set to No.