|
|
|
|
|
The Integrity Monitor Adjustment view gives numerical information on the status of the adjustment. After an adjustment has been performed, the view shows for each point and station its name and the last processing time.
Above the table, the value of the standard error of unit weight is shown.
Note - For Integrity Monitor modules under an engine processing GNSS data, the following applies: If the standard error of unit weight is less than 1.0, the 3-s standard deviations of the parent processor are applied instead of the standard deviations computed by the adjustment.
Points / stations with fixed coordinates display the 
status icon.
This view is not available for the Integrity Monitor module under a GNSS processing engine, if the parent does not process baselines.