|
|
|
|
|
Several module types (for example the RTK Engine, if logging its rover position results is enabled) display a Chart view. The Chart view graphically displays the original data as well as the results after a filter has been applied. All displayed data refers to the selected baselines or station.
All charts show the same general behavior. They have a common set of chart options you can modify; you can switch data sets on and off as desired, you can zoom into them, you can save their contents to graphic or data files, and you can print them. For a detailed description of how to get the best out of the chart views see the Chart Views section of this Help.
Only displayed, if the processing engine creates baseline vectors. Use the selection field to select the baseline between the Base station and the Selected station for which the curves display the coordinate component over time.
Only displayed, if the processing engine outputs absolute positions. Use the selection field to select the station for which the curves display the coordinate component over time.
Use the selection field to select a coordinate component of the selected baseline / station. Available selections are D Easting, D Northing, and D Height.
The diagram displays for the selected baseline / station and the selected coordinate component two results: The darker curve shows the filtered results, while the lighter one displays the incoming, unfiltered measurements over time.